Hoover AI 1040 User Instruction page 32

Installation & Testing
After removing the machine from the packaging, proceed
as follows:
On the back of the machine
1) Unscrew the centre brace A, the two side screws C
and remove the transverse bracket D and the relevant
plastic spacer.
2) Unscrew the 2 B braces and remove them. This will
cause 2 plastic spacers to fall into the machine.
3) Tilt the machine forward and remove the above-
mentioned plastic spacers.
4) Cover the holes using the caps enclosed
in the instructions envelope.
5) Fix the sheet of corrugated material on the
bottom as shown in picture.
6) Level the machine using the two adjustable rear feet.
How to change the position of the outlet hose
Remove the back panel by loosening the screws.
Remove the plugs I; take the outlet hose and put it,
into the hole that you want to use, after having
removed the plug H. To insert into the holes two clips F.
If you choose the outlet to be positioned on the
opposite side of the cabinet, fasten the hose by
passing it under the two clips F on the lower edge,
making sure that the hose is kept well-straight. To
tighten the clips. Stop the hole that is still open, using
the plug H.
Finally, fasten the hose on the outer side of the
cabinet using the semi-plugs I and then reposition the
back panel.
C A C D
B
F
I
62
Note: we recommend you keep the transverse bracket,
braces and screws to immobilise the machine for future
transit. The Manufacturers will not be responsible for
any possible damage to the machine caused by not
following the rules relating to releasing the mechanism.
The user is responsible for all costs of installation.
Water supply
B
The machine has an inlet hose with 3/4» threaded
ferrules fitted to the ends to attach between the threaded
connector on the appliance and the cold water supply.
The appliance must be connected to the water mains
using new hose-sets. The old hose-sets should not be
reused.
The appliance must only be connected to the cold water
supply.
Connection to a warm water supply, that is over 40°,
may damage certain delicate fabrics.
Acqua-stop
The fill hose supplied with this machine has a double skin
and incorporates a water valve. If the inner hose bursts the
valve will automatically shut off the water supply to prevent
flooding. The indicator turns red (A). Should this happen,
turn off the water supply immediately and have a new fill
hose fitted by Hoover Service.
H
Safety antitwist
device (press and
twist to remove
the washer)
Red button
blocked valve
indicator
A
63