Fleetwood 1999 American Tradition Parts And Service Manual page 91

4. In the plumbing utility compartment, turn the WATER TANK
BYPASS valve, the COLD WATER DRAIN valve, and the
HOT WATER DRAIN to the right (clockwise) to close them,
if necessary.
5. On model 40VS turn the handle on VALVE 2 horizontal. On
model 38TF, turn the handle on VALVE 2 horizontal and
turn the handle on VALVE 1 towards the front of the vehicle.
6. Attach the free end of the city water supply hose to the city
water inlet fitting. Tighten securely ..
7. Turn the city water supply valve ON. The system is now
pressurized by the city water supply. Water is available at
the exterior utility washdown faucet and all interior faucets.
8. Open each faucet in the .galley and bathroom. After any
sputtering stops and water flows freely, close the faucet.
As long as you are connected to a city water supply, you
have pressurized water at all faucets. You do not need to run
the water pump. With the valves set this way, the water pump
is isolated from the system.
To disconnect the city water:
1. Turn OFF the city water supply.
2. Remove the hose from the city water supply valve.
3. Drain and store the hose on shelf provided.
AMEflicAN
T
IlAdirioN
PlUMbiNCj SYSTEMS