Washer Fluid - Cadillac Escalade 2014 Owner's Manual

Cadillac Escalade/Escalade ESV Owner Manual (GMNA-Localizing-MidEast-
6963932) - 2014 - crc - 5/21/13
10-24 Vehicle Care
What to Use
To determine what kind of fluid to
use, see Recommended Fluids and
Lubricants on page 11-7. Always
use the proper fluid.
Notice: Use of the incorrect fluid
may damage the vehicle and the
damages may not be covered by
the vehicle's warranty. Always
use the correct fluid listed in
Recommended Fluids and
Lubricants on page 11-7.

Washer Fluid

What to Use
When windshield washer fluid needs
to be added, be sure to read the
manufacturer's instructions before
use. Use a fluid that has sufficient
protection against freezing in an
area where the temperature may fall
below freezing.
Adding Washer Fluid
The vehicle has a low washer fluid
message on the DIC that comes on
when the washer fluid is low. The
message is displayed for
15 seconds at the start of each
ignition cycle. When the WASHER
FLUID LOW ADD FLUID message
displays, washer fluid will need to
be added to the windshield washer
fluid reservoir.
Open the cap with the washer
symbol on it. Add washer fluid until
the tank is full. See Engine
Compartment Overview on
page 10-5 for reservoir location.
Black plate (24,1)
Notice
When using concentrated
washer fluid, follow the
manufacturer instructions for
adding water.
Do not mix water with
ready-to-use washer fluid.
Water can cause the solution
to freeze and damage the
washer fluid tank and other
parts of the washer system.
Fill the washer fluid tank only
three-quarters full when it is
very cold. This allows for
fluid expansion if freezing
occurs, which could damage
the tank if it is
completely full.
Do not use engine coolant
(antifreeze) in the windshield
washer. It can damage the
windshield washer system
and paint.