Microsd Card - Midland xtc-200 Instruction Manual

Getting to Know the XTC-200
Battery
1. To insert the battery pack, push down the battery door latch on the right side
of the camera. Door will release. Push forward to remove.
2. Install the Lithium battery pack.
3. Return battery door and click into place.
Battery Status Indicator
Solid Green
Solid Red
Blinking Red*
No Light
Note: When the red battery LED begins blinking, be prepared to charge the battery because the camera will stop
recording at this point.
Micro SD Card
1. Open and fold down the back rubber cover.
2. Insert Micro SD card into slot observing proper direction (shown sideways).
3. Return rubber flap into place.
NOTE: XTC-200 supports up to 32GB memory card size.
Recording
1. Move the RECORD switch forward. This turns the camera on.
2. The battery indicator will light from red to green. The SD card indicator will light green. The record indicator will begin
flashing red after 8 seconds. This indicates the camera is capturing video.
3. To stop recording, move the RECORD switch back to the off position.
Note: The camera will continue recording for 3 seconds after toggling the switch to the off position.
SD card LED Status
Green
Orange
Red
Flashing Red
Flashing Green
Memory Size
512 MB
1 GB
2 GB
4 GB
8 GB
16 GB
32 GB
Note: The camera automatically splits the video into 2 GB segments.
Meaning
Indicates full battery life
Indicates half battery life
Indicates low battery life
Batteries are dead
Meaning
1 GB or more avai lable
512 MB to1 GB available
Below 512 MB available or no MicroSD card installed.
Cannot read the card
Indicates card has been reformatted.
HD Record Time
6.5 minutes
13 minutes
26 minutes
52 minutes
104 minutes
208 minutes
416 minutes
SD Record Time
9.5 minutes
19 minutes
38 minutes
76 minutes
152 minutes
304 minutes
608 minutes