Cadillac CTS 2014 Owner's Manual page 387

Cadillac CTS Owner Manual (GMNA-Localizing-MidEast-6882317) - 2014 -
CRC - 9/19/13
5. Connect one end of the red
positive (+) cable to the remote
positive (+) terminal on the
discharged battery.
6. Connect the other end of the red
positive (+) cable to the
positive (+) terminal of the good
battery.
7. Connect one end of the black
negative ( ) cable to the
negative ( ) terminal of the good
battery.
8. Connect the other end of the
black negative ( ) cable to the
remote negative ( ) grounding
terminal for the discharged
battery.
9. Start the engine in the vehicle
with the good battery and run
the engine at idle speed for at
least four minutes.
10. Try to start the vehicle that had
the dead battery. If it will not
start after a few tries, it
probably needs service.
Caution
If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
(Continued)
Black plate (75,1)
Vehicle Care
Caution (Continued)
Always connect and remove the
jumper cables in the correct order,
making sure that the cables do
not touch each other or other
metal.
Jumper Cable Removal
Reverse the sequence exactly when
removing the jumper cables.
10-75