Time Setting; How To Use The Stopwatch - Level VD53 User Manual

TIME SETTING

- Before setting the time, check that the chronograph measurement is stopped.
1) Pull out the crown to the first click.
2)Turn the crown clockwise until the
preview day's date appears.
3) Pull out the crown to the second click
when the second hand is at the 12 o'clock
position. It will stop on the spot. Set the
hands to the desired time of the day
(make sure AM/PM is set correctly) by turning the crown.
- When the crown is at the second click position, do not press any button.
Otherwise the chronograph hands will move.
4) Push the crown back in the normal position in accordance with a time signal.
- Do not set the date between 9:00 P.M. and 1:00 A.M, otherwise the day may
not change properly. If it is necessary to set the date during the time period,
firstly change the time to any time outside it, set the date and then reset the
correct time.

HOW TO USE THE STOPWATCH

- The measurement time is indicated by the stopwatch hands that move
independently of the center hands (and 24-hour hand where applicable).
- The stopwatch can measure up to 60 minutes
Standard measurement (e.g. 100m race)
Press the buttons in the following order :
Set the day Set the time
Accumulated elapsed time measurement (e.g. basketball game)
Split time measurement (e.g. 5,000 m race)
* Restart and stop of the stopwatch can be repeated
as many times as necessary by pressing button A
* Measurement and release of the split time can be repeated
as many times as necessary by pressing button B