Cadillac ATS 2015 Owner's Manual page 286

Cadillac ATS Owner Manual (GMNA-Localizing-MidEast-8087807) - 2015 -
crc - 6/2/14
10-46 Vehicle Care
4. Use the five-way DIC control on
the right side of the steering
wheel to scroll to the Tire
Pressure screen under the DIC
info page. See Driver
Information Center (DIC) on
page 5-23.
5. Press and hold the SEL button
located in the center of the
five-way DIC control.
The horn sounds twice to signal
the receiver is in relearn mode
and the TIRE LEARNING
ACTIVE message displays on
the DIC screen.
6. Start with the driver side
front tire.
7. Place the relearn tool against
the tire sidewall, near the valve
stem. Then press the button to
activate the TPMS sensor.
A horn chirp confirms that the
sensor identification code has
been matched to this tire and
wheel position.
8. Proceed to the passenger side
front tire, and repeat the
procedure in Step 7.
9. Proceed to the passenger side
rear tire, and repeat the
procedure in Step 7.
10. Proceed to the driver side rear
tire, and repeat the procedure
in Step 7. The horn sounds two
times to indicate the sensor
identification code has been
matched to the driver side rear
tire, and the TPMS sensor
matching process is no longer
active. The TIRE LEARNING
ACTIVE message on the DIC
display screen goes off.
11. Press STOP to turn the
ignition off.
12. Set all four tires to the
recommended air pressure
level as indicated on the Tire
and Loading Information label.
Black plate (46,1)
Tire Inspection
We recommend that the tires,
including the spare tire, if the
vehicle has one, be inspected
for signs of wear or damage at
least once a month.
Replace the tire if:
The indicators at three or
more places around the tire
can be seen.
There is cord or fabric
showing through the tire's
rubber.
The tread or sidewall is
cracked, cut, or snagged
deep enough to show cord or
fabric.
The tire has a bump, bulge,
or split.