Chicago Pneumatic CP 0009 Safety And Operating Instructions Manual page 15

CP 0009, CP 0014
NOTICE Never cool a hot insertion tool in water,
it can result in brittleness and early failure.
WARNING Ejected insertion tool
If the tool retainer on the machine is not in a locked
position, the inserted tool can be ejected with force,
which can cause personal injury.
Before changing the insertion tool, stop the
►
machine, switch off the compressed air supply
and bleed the machine by activating the start and
stop device.
Before fitting the insertion tool
Check that the tool shank is of the correct size and
length for the chuck used. The shank must be clean
and the tool must be in good condition. Shanks
which are chipped, rounded, out of square or too
hard on the striking end will operate inefficiently
and cause premature piston failure.
Inspect the drill steel:
A dull drill steel will slow down the drilling speed
and overstrain the drill mechanism. When changing
drill steel make sure that the new one is the correct
size to follow your previous bore.
Before drilling, check that the flushing hole in the
drill steel is not blocked.
NOTICE If burrs are raised around the four ball
slots in the shank of the insertion tool, polish them
smoothly. It will result in easier entry and removal
of the insertion tool, and also an efficient operation
of the chuck.
9800 0547 90 | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Fitting the insertion tool
Whenever fitting the insertion tool the following
instructions must be observed:
CP 0009
1.
Pull the tool retainer and hold it backwards in
the direction of the arrow, insert the insertion
tool in the chuck at the same time.
2.
When the insertion tool bottoms, lock the tool
retainer by releasing it. Check the lock function
by pulling the inserted tool sharply outwards.
15