JVC MX-GT91R Service Manual page 9

Removing the tuner board
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
1. Disconnect the card wire from connector CN1 on the
tuner board on the right side of the body.
2. Remove the plastic rivet fixing the tuner board.
3. Remove the two screws F on the back of the body.
Removing the rear cover / rear panel
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
1. Remove the screw G attaching the rear cover on the
back of the body.
2. Push each tab of the four joints b in the direction of
the arrow and release.
3. Remove the twelve screws F
panel.
4. Release the joints c on each lower side of the rear
panel using a screwdriver and remove the rear panel
backward.
Note : Remove the tuner board in case of necessity.
Joint c
Fig.15
(See Fig.11 and 12)
(See Fig.12 to 15)
attaching the rear
(Refer to Fig.21)
Rear panel
Plastic rivet
CN1
Fig.11
G
F
Joint b
Rear cover
Fig.12
F
F
F
Fig.13
Rear panel
Fig.14
MX-GT91R
Tuner board
Rear panel
Rear panel
Joint b
Rear panel
F
Joint c
1-9