Outdoor Leisure TD101A Owner's Manual page 6

ASSEMBLy
Continued
4. Install electronic ignitor through control
panel as shown in Figure 4, page 5. Screw
retainer ring and ignitor cap on from outside
panel. Attach ignitor ground wire to ignitor.
5. Remove wire tie and packing material
from regulator located underneath burner
support plate.
6. Position burner support plate on top of
panels while carefully inserting control
valve through hole in control panel.
7. Attach control valve bracket to table
control panel with  screws (C). Attach
control knob to control valve from outside
of heater. See Figure 5.
8. Attach burner support plate to panels with
4 screws (C) (see Figure 5).
9. Attach emitter screens to emitter brackets
with 4 screws (C) as shown in the Figure 5.
10. Attach emitter cap to emitter brackets with
 screws (C) as shown in Figure 5.
All
Screws
(C)
Burner
Support
Plate
Figure 5 - Assembling Emitter and
Attaching Burner Support Plate
6
Emitter Cap
Emitter
Screen
Emitter
Bracket
Control Valve
Underneath
Burner
Support Plate
Control
Knob
Hole for
Control
Valve
www.desatech.com
11. Attach emitter assembly to burner support
plate with  screws (C) (see Figure 5).
1. Model TD109A only: Place 3 screens
around grate pillars. For all models, place 3
table decorative grate pieces around grate
pillars. Attach to grate pillars with 4 screws
(C) per grate as shown in Figure 6.
All Screws (C)
Deco
Grate
Pillar
(Holes
closest to
edge should
be on the
bottom)
Figure 6 - Deco Grate and Grate Pillar
Assembly
Figure 7 - Attaching Grate Assembly to
Table Decorative
Grate (Models
TD101A, TD103A
and TD111A
TD109A
Screw (C)
through
Deco
Grate
Pillar
Burner
Support
Plate
Ring
Retainer
Heater
1393-01A
shown)
Screen
(Model
only)