Outdoor Leisure TD101A Owner's Manual page 5

Hardware packet contains the following items
shown on pages 1 through 14:
Electronic Ignitor (1), Ignitor Wire (1), Ground
Wire (1), Knob (1), Propane Tank Retention
Chain (1), Retention Hook (), and AA Bat-
tery (1).
Parts are referenced by designated letter
throughout assembly instructions. Hardware
packet contains the following (quantity used
in parenthesis):
Description
A 1" Screw (6)
B 5 mm Washer (6)
C 3/8" Screw (53)
D 3/8" Machine Screw (9)
E 10 mm Hex Nut (6)
F 7/10" Self Tapping Screw (9) 11584-01
A B
D E
Washer (B)
Heater Base
Figure 3 - Installing Support
Pillars into Base
1393-01A
ASSEMBLy
Part Number
119619-04
119600-0
11960-0
11974-01
119743-01
C
F
Support
Pillar
Lower
Table
Panel
Pillar
Screw
Support
(A)
Connector
Wheel
www.desatech.com
Continued
1. Locate table heater base and 3 lower table
support pillars with holes on one side only.
Making sure holes in pillars are oriented as
shown in Figure 3, slide support pillars into
base and attach with screws (A) and wash-
ers (B) through bottom  holes as shown.
. Position lower table panel and table control
panel onto base assembly as shown in
Figure 4. Make certain lower table panel is
on side of base with wheels. Using bottom 3
sets of holes only, attach panels to support
pillars with 1 screws (C) (see Figure 4).
3. Top sets of screws (C) will insert through
panels, through support pillars, then into
pillar support connectors as shown in
Figure 4 (6 screws). Make sure pillar sup-
port connectors are oriented as shown in
Figure 4. The side of connectors with one
hole should be facing outside heater and
hole should be at the top. For support con-
nectors closest to front opening, second
screw will only install through panels and
support connectors. Second screw will
secure connector (see Figure 4). Attach
ignitor ground wire with 1 screw as shown
in Figure 4 (ignitor installed in step 4).
Electronic
Ignitor
Figure 4 - Attaching Side Panels and Ignitor
Hole for
Table
Control Valve
Control
Panel
Screw
Installs
Through
Pillar
Support and
Connector
Only
Ignitor
Grounding
Wire
Screw (C)
5