Safety Instructions - DigiTech RP55 Owner's Manual

WARNING FOR YOUR PROTECTION
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLOW ALL INSTRUCTIONS
THE APPARATUS SHALL NOT BE ExPOSED TO DRIPPING OR SPLASHING LIqUID AND NO OBjECT FILLED WITH LIqUID, SUCH
AS vASES, SHALL BE PLACED ON THE APPARATUS
CLEAN ONLY WITH A DRY CLOTH.
DO NOT BLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOvES, OR OTHER APPARATUS (INCLUDING
AMPLIFIERS) THAT PRODUCE HEAT.
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the
other. A grounding type plug has two blades and a third grounding prong. The wide blade or third prong are provided for your safety. If
the provided plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit
from the apparatus.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.
MAINS DISCONNECT: The plug shall remain readily operable. For rack-mount or installation where plug is not accessible, an all-pole
mains switch with a contact separation of at least 3 mm in each pole shall be incorporated into the electrical installation of the rack
or building.
READ THE FOLLOWING:

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EqUIPPED WITH
A POWER CORD.
WARNING: THIS APPLIANCE SHALL BE CONNECTED TO A
MAINS SOCKET OUTLET WITH A PROTECTIVE EARTHING
CONNECTION.
The cores in the mains lead are coloured in accordance with the
following code:
GREEN and YELLOW - Earth BLUE - Neutral
As colours of the cores in the mains lead of this appliance
may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
• The core which is coloured green and yellow must be
connected to the terminal in the plug marked with the
letter E, or with the earth symbol, or coloured green, or
green and yellow.
• The core which is coloured blue must be connected to the
terminal marked N or coloured black.
• The core which is coloured brown must be connected to the
terminal marked L or coloured red.
This equipment may require the use of a different line cord,
attachment plug, or both, depending on the available power
source at installation. If the attachment plug needs to be
changed, refer servicing to qualified service personnel who
should refer to the table below. The green/yellow wire shall
be connected directly to the units chassis.
WIRE COLOR
CONDUCTOR
Normal
L LIVE BROWN
N NEUTRAL BLUE
EARTH GREEN/
E
GND YEL
WARNING: If the ground is defeated, certain fault conditions
in the unit or in the system to which it is connected can result
in full line voltage between chassis and earth ground. Severe
injury or death can then result if the chassis and earth ground
are touched simultaneously.
BROWN - Live
Alt
BLACK
WHITE
GREEN