Edge Guide - Dremel 335 Operating/Safety Instructions Manual

DM 2610920458 05-12_DM 2610920458 08-10 5/14/12 11:18 AM Page 8
1. Install the edge guide to the plunge router
mounting blocks (Fig. 12).
2. Place parallel guide against work surface
with router bit in desired position.
3. Tighten thumbscrews.
Routing with Edge Guide
Slide the flattened side of the edge guide
along the work surface.
Routing Arcs and Circles
1 Remove the edge guide and attach the cir-
cle guide bracket to the guide rods (Fig.
13).
2. Use the finishing nail provided as a com-
pass point. Set the circle guide for the
desired radius.
3. Place the nail through the hole in the guide
and place the nail at the center of the
desired radius to be cut.

Edge Guide

Installation
Mounting
Blocks
FIG. 13
Finishing
Nail
8
FIG. 12
Edge
Guide
Edge
Guide