Table of Contents
Advertisement
6. Mix the recommended antifreeze with an equal amount of low-
mineral or distilled water and fill the reservoir to maximum, as
illustrated.
7. Loosen the air bleed bolt in the thermostat housing, then fill the
radiator to the filler neck with the coolant mixture. Tighten the
bleed bolt as soon as coolant starts to run out in a steady stream
without bubbles.
FILLER
NECK
8. With the radiator cap off, start the engine and let it run until
warmed up (fan goes on at least twice). Then, if necessary, add
more coolant mixture to bring the level back up to the filter neck.
9. Put the radiator cap on, then run the engine again and check for
leaks.
Fill to
here
Fill to here
Hide quick links:
Advertisement
Table of Contents
