Group 1, 2, 3, suitable for children 9 - 36kg (24 pages)
Summary of Contents for Mountain Buggy Peppy
Page 1
READ FOR YOUR CHILD'S SAFETY THESE INSTRUCTIONS CAREFULLY BEFORE USE peppy ™ KEEP FOR FUTURE REFERENCE...
Page 2
The peppy complies with requirements applicable in market ™ of sale For rights & remedies, refer www.mountainbuggy.com/warranty Please register your product purchase through our online warranty registration by visiting: www.mountainbuggy.com/register mountainbuggy.com...
Page 3
Congratulations on choosing your new car seat! Features Instructions Configurations Product Care Safety Warnings...
Product care GENERAL INSTRUCTIONS CLEANING & CARING Check your car seat for cuts & bruises. If your product Group 0+ is damaged in any way , or you’re not sure how to use it, please consult our web support from where you can Suitable for birth to 13kg.
Page 5
• Store in a safe place when it is not being used. Avoid 4. If in doubt, consult Mountain Buggy placing heavy objects on top of it. or a retailer.
Page 6
Safety Warnings WARNINGS • It is important that the seat belt be correctly routed and the child seat held • PLEASE READ THOROUGHLY BEFORE down on the upholstery as firmly as COMMENCING INSTALLATION AS AN possible to ensure maximum protection INCORRECT INSTALLATION COULD BE for the child occupant.
Page 7
Safety Warnings • A car’s interior can become very hot if • Never place your child seat on a table or the car is left parked in direct sunlight. It work surface. is therefore recommended that the child • This seat can be used for children of seat, when not in use, is covered by a 0−13kg in weight and in conjunction with towel etc.
Page 8
Safety Warnings and the heavier occupants in the front of • The car seat is only suitable for use in the vehicle. vehicles fitted with 3 point safety belts, • Do not allow your child seat to come into approved to UN/ECE regulation 16 or contact with corrosive substances e.g.
Page 9
Features Sunhood Diagonal belt guide Carry handle Harness Handle adjusters Fabric cover Lap belt guide Capsule release buttons Harness buckle Harness adjuster button Harness adjuster strap Isofix connector bars...
Page 10
Instructions 1. Open the harness buckle (press the red release button). 2. Place your child into the child seat. Put the shoulder straps over the child’s shoulders. 3. Slot together the two plastic sections of the buckle connectors. 4. Slide the two connectors into the slot in the top of the buckle until they “click”...
Page 11
Instructions The harness should be adjusted as tightly as possible without causing discomfort to the child. A loose harness is dangerous and should be checked each time that you use the seat. 1. To tighten the harness pull down on the adjustment strap until the harness is appropriately firm.
Page 12
Instructions WARNING: This car seat can only be fitted into the passenger seat of a car with a lap and diagonal seat belt and no air bag. APPROVED SEAT BELT TYPES: Your child seat must only be installed rear facing using a lap and diagonal seat belt in the rear pas- senger seat of the car.
Page 13
Instructions Danger! In an accident enormous forces occur. Never try to secure a child on your lap with the vehicle seat belt or by holding onto them. Secure your child in the car seat for every journey! Always secure the child seat in a rear-facing position in the vehicle.
Page 14
Instructions 1. With the child seat rearward facing, press it firmly against the carseat backrest. Route the lap section of the adult safety belt through the lap belt guides and fasten the car seat belt. 2. Place the diagonal belt in the diagonal seat belt guide at the back of the seat.
Page 15
Instructions To adjust the handle from one position to another: Caution! Always ensure that the handle is locked in 1. Press button on both sides of the handle at the position, the harness is correctly fitted and the swivel point and rotate the handle forwards or buckle fastened before lifting your car seat.
Page 16
Instructions peppy use only original mountain buggy car seat adapters to secure capsule to a buggy.
Page 17
Instructions This child seat can be used as a travel system in conjunction with selected strollers Installing: Having correctly attached an appropriate car seat adapter (sold separately) to your stroller, test that the child seat is fully attached by pulling the child seat up and forward;...
Need help?
Do you have a question about the Peppy and is the answer not in the manual?
Questions and answers