Provari Radius Components - Provape Provari Radius Owner's Manual

ProVari Radius Components

Tanks, cartomizers and atomizers screw into the top plate (1).
Make sure you load these devices with your fluid of choice before attempting to use the Radius.
The top plate (1) is permanently attached to the device. Do not attempt to remove it.
The main Button (2) activates the heating element inside the tank which creates the vapor.
This button is also used to change the user settings on the ProVari Radius. The two smaller buttons are
used to change power settings. There are some shortcuts to turning the device on/off and locking the
adjustment of power using these smaller buttons. We will review these later in this manual.
Main Body (3)
The End Plate (4) is removed to install the battery. The Radius was designed to be charged and updated
through the Micro-USB port (7). Should you ever need to change the battery, it is accessed by removing
the End Plate.
Refer to the Battery instructions for more information about charging and installing a battery.
The Window (5) shows the Wattage settings, battery power and other modes as well as error codes in the
event of a malfunction.
The bottom plate is held in place with two thumb screws
(6). To access the battery, remove these two screws
and you can replace the battery when needed. Never
tighten the thumb screws too tight when installing.
USB Charging and PC software updates (7) This
MicroUSB port is used to charge your device and
update the internal software as new updates are
available.
8