Selection Of Blades - K-EIKO EJS120PV Operator's Manual

6. Angular cutting
Set the chip cover to the first step. (Fig. 5)
To adjust the angle of inclination; loosen the base
bottom screw, shift the base position to the side
groove of the semicircular portion, align the scale on
the base semicircular portion (figures engraved on
the scale indicate the angle of inclination) with the
housing edge line, and thoroughly tighten the base
bottom screw. (Fig. 10 and 11)
Scale
CAUTION
Set the screw to the opposite side of the inclining
side when using the guide. (Fig. 12)
4mm
screw
(8mm)
Guide
Base
5
Fig. 10
Side groove
Housing edge
line
Fig. 11
Fig. 12
7. Dust produced in operation
CAUTION
To prevent accidents, turn the switch off and remove
the plug from the power supply when not in use.
For instruction on using the dust collector and
applicable cutting debris, please read the dust
collector instruction manual.
The dust produced in normal operation may affect
the operator's health. Either of following way is
recommended.
a) Wear a dust mask
b) Use external dust collection equipment
When using the external dust collection equipment,
connect the rubber adapter (accessory of external
dust collection equipment) with end the of hose from
external dust collection equipment.
Then connect the another end of rubber adapter with
the hose attachment part that positioned in rear end
of jig saw. (See Fig. 13)

SELECTION OF BLADES

1. Accessory blades
To ensure maximum operating efficiency and results
it is very important to select the appropriate blade
best suited to the type and thickness of the material
to be cut. One type of blade is provided as standard
accessory. The blade number is engraved in the
vicinity of the mounting portion of each blade. Select
4mm
appropriate blades by referring to Table 1.
screw
(8mm)
Hose
attachment part
Fig. 13