Bulb Replacement - Swift Group Sprite Alpine 2 Technical Handbook

Bulb replacement

SPRIte ROaD LIght
BuLB aCCeSS
StOP / taIL / InDICatOR anD
ReVeRSe LamPS
Bulb access is from front / via lense of each
lamp.
Remove 2x screws from each light lense and
withdraw lense.
Bulbs are a bayonet fitting – apply slight
pressure on bulb towards light fitting, and twist
to release.
Reverse procedure to re-fit bulb and lense.
Take care when replacing stop/tail lamp bulb,
that orientation of bulb is correct – to check,
brake light operation should be brighter than tail
lamp operation.
ReaR CentRaL FOg LIght
Bulb access is from front / via lense of lamp.
Remove 2x screws from light lense and
withdraw lense.
Bulb is a bayonet fitting – apply slight pressure
on bulb towards light fitting, and twist to release.
Reverse procedure to re-fit bulb and lense.
uPPeR ReaR SIDe POSItIOn LamPS (ReD /
CLeaR LenSe)
Lense is removed from base to access bulb.
Carefully insert small flat bladed screwdriver
into recess in lower edge of lamp base. Apply
pressure to release locking barb.
Lift lense upwards and away from lamp base,
lower edge first.
Lever bulb out of retaining clips.
Reverse procedure to re-fit bulb and lense.
numBeR PLate LamPS
Bulb access is from the front / via lense of each
lamp.
12
Remove the two screws in the lense of the lamp.
Lever the bulb out of retaining clips.
Reverse the procedure to re-fit a new bulb and
the light lense.
FROnt maRkeR POSItIOn LamPS
Bulb access is from rear of lamp.
Remove 2x screws from light fitting, and
withdraw whole fitting from caravan front panel.
Harness plugs into bulb holder – Twist bulb
holder relative to lamp body to release bulb
holder from lamp body.
Bulbs are push fit into bulb holder – pull bulb
directly away from holder to release.
Reverse procedure to replace bulb in holder,
holder in lamp and lamp onto caravan body.
SIDe maRkeR POSItIOn LamPS
Bulb access is from rear of lamp. First check
from within caravan if the rear of the lamp is
accessible:
If rear of light is accessible:
Harness plugs into bulb holder – Twist bulb
holder relative to lamp body to release bulb
holder from lamp body.
Bulbs are push fit into bulb holder – pull bulb
directly away from holder to release.
Reverse procedure to replace bulb in holder
and holder in lamp.
If rear of light is not accessible:
Remove 2x screws from light fitting, and
withdraw whole fitting from caravan body.
Harness plugs into bulb holder – Twist bulb
holder relative to lamp body to release bulb
holder from lamp body.
Bulbs are push fit into bulb holder – pull bulb
directly away from holder to release.
Reverse procedure to replace bulb in holder,
holder in lamp and lamp onto caravan body.
13