Overheat-Alert Indicator; Analog Trim Meter; 6Y8 Multifunction Meters; 6Y8 Multifunction Tachometers - Yamaha F50F Owner's Manual

Instruments and indicators
Use the oil dipstick to check the re-
maining oil quantity. For further infor-
mation, see page 43.
EMU26574

Overheat-alert indicator

If the engine temperature rises too high, this
indicator will flash. For further information on
reading the indicator, see page 37.
ECM00052
NOTICE
Do not continue to run the engine if the
overheat-alert indicator is on. Serious en-
gine damage will occur.
EMU26611

Analog trim meter

This gauge shows the trim angle of your out-
board motor.
32
Memorize the trim angles that work best for
your boat under different conditions. Adjust
ZMU04754
the trim angle to the desired setting with the
power trim and tilt switch.
EMU31653

6Y8 Multifunction meters

Multifunction meters have 6 kinds of meter
units; tachometer unit (square or round
types), speedometer unit (square type),
speed & fuel meter unit (square or round
types), and fuel management meter (square
type). The indicator system is slightly differ-
ent between the round and square types.
Check the model and type of your unit care-
fully. This manual describes mainly the alert
indicators. For more details on setting
meters or changing indicator systems, see
the attached operation manual.
EMU36182

6Y8 Multifunction tachometers

The tachometer shows the engine revolu-
tions per minute. It has functions of trim
meter, adjusting trolling speed, cooling wa-
ZMU04715
ter/engine temperature display, battery volt-
age display, total hour/trip hour display, oil
pressure display, water detection alert, en-
gine trouble alert, and periodic maintenance
notification. If optional sensors are connect-
ed to the unit, cooling water pressure display
will be available. For the optional sensor,
consult your Yamaha dealer. The tachome-
ZMU04581