Trouble Shooting/Others; Troubleshooting; Battery Pack And Power - Sony SLT-A37 Instruction Manual

Troubleshooting

If you experience trouble with your camera, try the following solutions.
Check the items on pages 184 to 192. Consult your Sony dealer or local
authorized Sony service facility.
1 Check the following items.
2 Remove the battery pack, and insert the battery pack again after
about 1 minute, and turn on the power.
3 Reset the settings (page 167).
4 Consult your Sony dealer or local authorized Sony service facility.

Battery pack and power

The battery pack cannot be installed.
• As you insert the battery pack, use the tip of the battery pack to push the
lock lever (page 21).
• You can use an NP-FW50 battery pack only. Make sure that the battery is
NP-FW50.
The remaining battery indicator is incorrect, or sufficient remaining
battery indicator is displayed but the power runs out too quickly. Cannot
turn on the camera.
• This phenomenon occurs when you use the camera in an extremely hot or
cold location (page 195).
• The battery pack is discharged. Install a charged battery pack (page 19).
• The battery pack is dead (page 204). Replace it with a new one.
• Install the battery pack correctly (page 21).
The power turns off suddenly.
• If you do not operate the camera for given period of time, the camera turns
to power saving mode and nearly shuts down. To cancel the power save,
184