Troy-Bilt TB25GHT Operator's Manual page 10

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
WARM ENGINE START
1. Move ignition switch to the "RUN (I)" position.
2. Place choke in PARTIAL CHOKE "
8).
3. Grasp throttle handle firmly, depress safety trigger, and
squeeze throttle trigger to FULL position.
4. Pull starter rope briskly until engine starts, but no more
than 6 times. Keep throttle at FULL position until engine
runs smoothly. Move choke lever to "
5. If engine does not start, place choke lever in RUN " "
position and pull starter rope 5 more times. If engine
still does not start it is probably flooded. Wait 5 minutes
and repeat procedure with choke lever in RUN " "
position and throttle full open.
IDLING/CARBURETOR ADJUSTMENT
1. Occassionally, due to atmospheric conditions such as
altitude it might be necessary to make slight adjustment
to idle speed.
2. Insert phillips or flat screwdriver on screw (A) (figure 9).
Turn 1/8 turn clockwise to increase idle speed and 1/8
turn counterclockwise to decrease idle speed.
A
STARTING/STOPPING INSTRUCTIONS
" position (Figure
" position.
Fig. 8
Fig. 9
www.mymowerparts.com www.mymowerparts.com
STOPPING THE ENGINE
Emergency Stopping Procedure. When it is necessary
to stop engine immediately, DEPRESS the OFF "STOP
" switch until the engine stops completely (Figure 10).
Normal Stopping Method. For normal stopping, release
trigger and allow engine to return to idle speed. Then
DEPRESS the OFF "STOP
stops completely. (Figure 10)
10
" switch until the engine
Fig. 10