Dimplex DX 410 Installation And Operating Instructions Manual page 8

Wall convector heater
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 6
DX 410, DX 415, DX 420, DX 425, DX 430
5
Operation
The room temperature is regulated using the infinitely
adjustable thermostat (C). If the rotary knob is set to
the lowest setting i.e. to the extreme left (see figure),
the thermostat switches the heating device on at an
ambient temperature of approx. 5°C.
The heating device is switched on and off using the
power switch (D).
Two heating levels (I = 1000W or II = 2000W) can be
selected using the operating mode switch (E).
The red light illuminates when the device is in heating
operation.
ATTENTION!
Depending on the size of the room, heat requirement
and thermostat setting, rooms may overheat if the
heating is not controlled. This can be dangerous for
people who are not able to leave the room as it gets too
hot.
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
D-95326 Kulmbach
Subject to modifications without prior notice
EN-8
6
Protection Against Overheating
If the permissible temperature is exceeded, the heating
device switches off automatically. If this occurs, pull the
mains plug out and leave the device unplugged for a
few minutes, so that the temperature limiter can switch
back again.
Then remove the cause e.g. when the air grid is
blocked or covered. When the device has cooled suffi-
ciently, it can be started up again.
7
Faults
If the heating device does not give off heat, check the
following points:
Is the power switch (B) in the ON position?
Has the thermostat been set to the desired temper-
ature?
Has the overheat protection been triggered? See
chapter 6!
Is the fuse in the fuse box switched on?
If you cannot remedy the fault, please contact your
electrical retailer. To process your order, please state
the device type as well as its production number (E
No.) and manufacturing date (FD). This information is
listed on the type plate.
8
Cleaning
To clean the device, first disconnect it from the mains
and allow it to cool down. Clean the outside of the unit
using a soft, damp cloth. Do not use scouring powder
or furniture polish as this may damage the surface.
Dust which gathers inside the device can be removed
from the outside using a vacuum cleaner.
9
Warranty
Please contact your local dealer for information on the
warranty conditions. The warranty is not valid without a
sales receipt marked with the date of purchase.
10 Note on Disposal
Do not dispose of the unit with general house-
hold waste. The device must be taken to a local
waste disposal plant.
Phone number: +49 9221 709-564
Fax:
E-Mail: 09221709589@dimplex.de
www.dimplex.de/en
DX410_430_gb · 04/15/B
+49 9221 709589
www.dimplex.de/en

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dx 415Dx 425Dx 430Dx 420

Table of Contents