Gearmotor - Philips Saeco Gaggia Unica RI 9933 Service Manual

GAGGIA UNICA
7.9.

Gearmotor

F
D
A
Saeco International Group
E
The following are located inside the compartment
protected by the casing:
- Electric motor (A) with gears (B) and (C) for transmission
and timing of the dispensing unit.
B
- Dreg drawer presence sensor (D).
- Dispensing head present microswitch (E).
- Microswitch (F) detecting brewing unit home and work
C
positions.
- Remove the gear (C) that meshes with the motor
A
transmission shaft.
- Remove the large gear (B).
- Remove the motor (A), complete with transmission shaft.
B
Replace the gear (B), making sure that the imprint of the
arrow is aligned with the opening containing the pin (P).
P
When replacing the motor and the transmission shaft, make
sure the guide runners (L) are in the right position.
Grease the shaft thoroughly and evenly.
Loosen the screws as illustrated and remove
the boiler pin.
Loosen the screws as illustrated and
remove the gearmotor cover.
Rev. 01
07 DISASSEMBLY
Page / 07
05