Using Your Tv; Status Light; Standby Mode Energy Savings; Watching Broadcast Tv Channels - Insignia NS-43DR710NA17 Roku TV User Manual

NS-43DR710NA17/NS-50DR710NA17/NS-55DR710NA17

Using your TV

This section provides information on using the day-to-day features of your TV.

Status light

Your TV has a single status light on the front panel. It goes on and off and blinks in different ways depending on the
status of your TV, as shown in the following table:
TV condition
On (screen is active)
Screensaver (screen is active) Off
Off (no power)
Off (standby)
Starting up from off state
On (receiving update from
USB)
Remote control command
received
Powering down to standby
mode

Standby mode energy savings

When you turn off your TV, it may remain in a higher power mode for a few minutes, after which it goes into a very low
power standby mode. If you turn on your TV again before it has entered the very low power mode, it turns on
immediately. After your TV goes into the lower power standby mode, it takes a bit longer to start up.

Watching broadcast TV channels

To watch broadcast TV, select the Antenna TV tile in the Home screen. Your TV remembers the last channel you
watched and starts with that channel playing.
Tip
You also can use the buttons on the TV panel to select Antenna TV, as explained in
Buttons

Changing channels

To change channels, you can do any of the following:
• Press the UP arrow to change to the next higher channel.
• Press the DOWN arrow to change to the next lower channel.
• Press the LEFT arrow to display the channel list, and then press the UP and DOWN arrows to move the highlight
through the list one channel at a time. Or press REWIND and FAST FORWARD to move the highlight through the list
one page at a time. When you've highlighted the channel you want to watch, press OK. (If you decide you don't want
to change channels, press the RIGHT arrow or BACK button).
• Press to switch to the previously tuned channel.
Note
If
Jump Back button on a universal remote. For more information, see
page 76.
Status indicator
Off
Off
On
Slow pulsing blink until
startup completes
Slow pulsing blink until
update completes
Dims on/off once
Slow pulsing blink until
your TV reaches standby Your TV is doing something.
on page 11.
is not available on your remote control, you can use
www.insigniaproducts.com
Meaning
Screen is communicating that your TV is
on.
Screen is communicating that your TV is
on.
Your TV is not connected to power.
Your TV is connected to power and ready
to use.
Your TV is doing something.
Your TV is doing something.
Your TV has received your command.
on the Roku App or the
Other devices on
49