Table of Contents
Advertisement
6
Step
Press the
(PAUSE) key to cancel PAUSE mode.
Adjusting the Sensitivity of the Registration-Mark Sensor
M A R K M O D E
M A R K P O S I T I O N
M A R K T Y P E
M A R K S I Z E
M A R K D I S T . A D J .
M A R K O F F S E T
M A R K S E N S O R A D J 1
M A R K S E N S O R A D J 2
M A R K A U T O S C A N
M A R K S E N S O R A D J
There may be instances when the registration-mark sensor does not function cor-
rectly, depending on how it is moved. If this happens, adjusting the sensitivity will
enable the sensor to perform detection correctly in most cases.
1
Step
Press the
(PAUSE) key to switch to PAUSE mode.
2
Step
Press the
(NEXT) or
A U T O R E G . M A R K
3
Step
Press the
(ENTER) key to display the Auto Reg. Mark submenu, and then
press the
(NEXT) or
M A R K S E N S O R A D J
4
Step
Press the
(ENTER) key to display the Mark Sensor sensitivity setting.
M A R K S E N S O R
5
Step
Use the
or
key to increase or decrease the setting within the range of "-5"
to "5," and then press the
the sensitivity, but makes the cutting plotter more susceptible to other influences
and less able to withstand noise. A negative value decreases the sensitivity, but
makes the cutting plotter less susceptible to other influences and more able to
withstand noise. To cancel the selection, press the
6
Step
Press the
(PAUSE) key to cancel PAUSE mode.
(PREV.) key until the following menu is displayed.
(PREV.) key until the following menu is displayed.
0
(ENTER) key to confirm. A positive value increases
4 – 21
(NEXT) or
(PREV.) key.
Hide quick links:
Advertisement
Table of Contents
