Maintenance; Changing / Replacing Spark Plug - ALDI 51488 User Manual

45cc Petrol Chainsaw

Maintenance

NOTE: This product is not suitable for repair or maintenance work by the
unskilled person. The following detail explains how the product is cleaned,
and basic maintenance / safety checks.
All other maintenance work must be carried out by service agents who are
experienced with both the mechanical and electrical aspects of this product.
NOTE: Before cleaning your chainsaw or carrying out any maintenance
procedures, make sure that the engine is off and is cool.
NOTE: Failure to maintain the following parts may result in reduced engine
performance.
Disconnect the Spark plug to prevent accidental starting. Maintenance
should be performed before and after each use. If the chainsaw is dropped
or appears to suffer any other significant impact, it is highly recommended
to perform all maintenance tasks before operation, and if there appears
to be an issue, refer to the troubleshooting chart, or take to an authorised
service agent.
Changing/replacing the Spark Plug
Regularly check the spark plug (16) for wear and
any build-up of carbon on the electrodes. Spark
plugs should be replaced every 10-15 hours of use.
1. Remove the air filter cover (14) by turning the
air filter cover knob (15) in an anti-clockwise
direction, and then remove the air filter (13)
(Fig AH). Once the cover and air filter has been
removed pull off the black rubber cap from the
spark plug. (Fig AI)
WARNING: To avoid damage to the spark
plug lead, ensure you hold the rubber cap
and not by the lead itself.
2. To remove spark plug (16) use the supplied
spark plug / spanner wrench (32) and turn in an
anti-clockwise direction to remove.
3. Check for oil on the electrodes and clean off any
excess. This can typically indicate that the fuel
mixture ratio maybe incorrect.
AFTER SALES SUPPORT
1800 909 909
(toll free)
AH.
AI.
e-mail: help@powertoolsupport.com
MODEL: №. YR-CS4500S • 04/2016 • 51488
Operation
27