Filling Up With Fuel And Oil - ALDI 51488 User Manual

45cc Petrol Chainsaw
CAUTION: A new chain (19) will stretch after just a few minutes of use.
Check and, if necessary, re-adjust the tool free chain tensioning dial (21).
A loose chain causes rapid wear to both the chain (19) and the guide bar
(18) and could derail causing a major safety hazard.
NOTE: Do not make ANY adjustments
with the chainsaw engine running.
Run the chainsaw for approximately
30 sec and then turn the chainsaw off.
Retest the chain.

Filling up with Fuel and Oil

WARNING: Fuel is very flammable. Avoid smoking or causing any
sparks or flames near fuel. Make sure that you stop the engine and
allow it to cool before refuelling the machine. Select outdoor bare
ground for fuelling and move at least 15m (49ft) metres away from the
fuelling point before starting the engine.
It is suggested to wear safety glasses when mixing fuel.
• Only use oil that is expressly labelled for use with air-cooled 2-stroke
engines. DO NOT use BIA or TCW (2-stroke water-cooling type) mixed oil.
The recommended mixing ratio is PETROL 40: OIL 1
• Use fresh unleaded fuel. Do not use ethanol based fuels.
• Poor quality fuel or oil may damage sealing rings, fuel lines or the fuel tank.
• Do not use waste or regenerated oil, it can damage the oil pump.
CAUTION. To maximise the lifetime of the engine, avoid the following:
• Do not use raw fuel, it will severely damage the engine very quickly.
• Do not run the tank dry during cutting, as this may cause damage to the
engine.
• Do not use oil meant for 4-stroke engines, it will cause spark plug fouling,
exhaust blocking and piston ring sticking.
• Do not use fuel mixtures that have been left standing for one month or
more, they can cause clogging of the carburettor.
• Before storing the chainsaw for an extended period, empty the fuel tank
(7), clean it then run the engine to empty the carburettor at idle speed.
NOTE: Do not discard an unwanted fuel container with household waste.
It must be taken to an authorised repository site.
NOTE: The guide bar, chain, oil pump and oil lines contain oil after the
chainsaw has been run. OIL will drain freely from these component after
the chainsaw has been turned OFF. Be aware or it may spill on to the
surface the chainsaw has been placed so be careful where the chainsaw
is located for both storage and transportation.
AFTER SALES SUPPORT
1800 909 909
(toll free)
TIGHT
LOOSE
e-mail: help@powertoolsupport.com
MODEL: №. YR-CS4500S • 04/2016 • 51488
Assembly
15