Engine Preparation; Chassis Preparation; Battery Preparation - Yamaha YTF2 Owner's/Operator's Manual

ENGINE PREPARATION

With the key removed and the spark
plug lead disconnected, turn the
clutch by hand until compression is
felt. This puts the valves in the
closed position.
CHASSIS
PREPARATION
1. Verify the tire pressure is set to:
Front: 140-160 kPa,
1.4-1.6 kgf/cm
Rear: 197-217 kPa,
2.0-2.2 kgf/cm
2. Clean exterior of the utility
vehicle and apply a rust inhibitor.
3. Cover the utility vehicle with a
breathable cover and store it in
a dry, well-ventilated area.
BATTERY
PREPARATION
1. Remove the battery from the
utility vehicle and store it in a
cool, dry place that stays
between 0˚C (32˚F) and 30˚C
(90˚F).
JW7
2 (20-23 psi);
(29-31 psi).
2
STORAGE
2. Have the battery recharged
every 60-90 days to keep it fully
charged. The battery must be
kept fully charged to avoid
damage.
3. Batteries like the one supplied
with your vehicle normally do
not require you to check the
water level inside the battery for
the one-year warranty period
provided by the manufacturer.
NOTICE
Do not allow cleaning solution to
enter battery cells. Serious bat-
tery damage can result.
4. Clean the top of the battery with
a solution of baking soda and
water, as necessary, to remove
corrosion.
1
2
3
4
5
6
7
8
9
10
11
8-2