Important Information - BMW 66 20 0 007 031 Installation Instructions Manual

Important information

The retrofit kit is for use within the BMW dealership organisation only.
Target group
The target group for these installation instructions is specialist personnel trained on BMW cars
with specialist knowledge of body electrical systems.
All work is to be carried out using current BMW
- Repair manuals (see Technical Information System),
- Circuit diagrams (see Diagnostics Information System),
in a rational sequence with the prescribed tools (special tools) and taking into account the
relevant health and safety regulations.
Installation information
The retrofit wiring harness is to be installed so that it cannot kink or chafe.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead terminals must
be used.
All work is shown on a LHD car. On RHD cars some work must be completed the opposite way
round.
All tightening torque values are to be taken from the current repair manuals and must be
observed.
Safety instructions
The current accident prevention regulations must be followed.
EN/3
Retrofit / Installation kit No. 66 20 0 007 031
Installation Instructions No. 01 29 0 137 628 Issue date: 02.2002