Brewing Iced Tea - Mr. Coffee TM30 Instruction Manual

BREWING ICED TEA

1. Fill the pitcher with fresh, cold water to the
desired water level capacity (1, 2 or 3 quarts). Do
not overfill.
2. Lift the water reservoir lid, rotate the shower head
out of the way and remove the brew basket. Pour
water into the water reservoir (Figure 1).
3. Place the brew basket back in its place, inserting a
4 cup MR. COFFEE
basket. Add the desired amount of tea (see the
Measurement Chart). You may now add sugar,
lemon or other flavorings to the brew basket to
suit your taste (Figure 2).
4. Rotate the shower head back into position so that
it is now over the brew basket. Close the water
reservoir lid.
5. Adjust the steeping lever to your desired brewing
strength. The farther the lever is to the left, the
stronger the tea.
6. Fill the pitcher with ice cubes to the desired ice
level marked on the pitcher (Figure 3). Replace
the pitcher lid with the pitcher spout cover in the
open position. If you are low on ice, you may
substitute cold water, refilling the pitcher to the
desired 1, 2 or 3 quart WATER level – DO NOT
fill to the ICE level as this will cause an overflow
when the tea brews.
7. Slide the pitcher towards the iced tea maker
with the pitcher spout open and fitting just
under the Steep Control, flush against the
appliance.
NOTE: If the pitcher and its lid are not pushed
snugly against the iced tea maker, hot water
and hot steam could escape and cause
injury.
8. Turn the iced tea maker on by plugging the power
cord into an electrical outlet and pushing the "on"
button firmly until the ON indicator light is
illuminated.
® paper filter into the brew
Figure 1
Figure 2
Figure 3
9