Miele G4920 Operating Instructions Manual page 60

Programme options
If "Optimise standby" is switched on
(see "Programme options - Optimise
standby"), the display will go out after
a few minutes, leaving just the Start
indicator light flashing slowly.
Press any button to switch the display
back on again for a few minutes.
The time up until the programme starts
will appear counting down in the dis‐
play in hours for durations above
10 hours, and in hours and minutes for
durations below this.
When the set time is reached, the pro‐
gramme selected will start automatical‐
ly. The time remaining will appear in the
display and the  indicator light will go
out.
How the Delay start time is shown in
the display:
up to 59 minutes:
e.g. 30 minutes = .
1 hour up to 9 hours 30 minutes:
e.g. 5 hours = .
10 hours and over:
e.g. 15 hours = 
60
Starting a programme before the De‐
lay start period has elapsed:
A programme can be started before the
Delay start period has elapsed.
Proceed as follows:
 Switch the dishwasher off with the 
button.
 Switch the dishwasher on again with
the  button.
 Select the programme you want.
 Press the Start button.
The programme cycle will begin. The
Start indicator light will come on.