Setting The Rinse Aid Dosage - Miele G4920 Operating Instructions Manual

Before using for the first time

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
If the "Adjust Sensor wash" programme
function (depending on model) has
been activated, the amount of rinse aid
dispensed in the Sensor wash pro‐
gramme can be higher than that set.
If spots appear on crockery and glass‐
ware:
 Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
 Decrease the rinse aid dosage.
28
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the Start button in and, whilst
holding it in, switch the dishwasher
on using the  button.
Keep the Start button pressed in for
at least 4 seconds until the Start indi‐
cator light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 Press the  button 3 times.
The  indicator will flash rapidly 3
times at intervals.
The dosage set will appear in the dis‐
play after .
The flashing sequence   will appear in
the display.
This indicates the factory default setting
3.
 Use the Start button to select the set‐
ting required.
Each press of the button moves you
up a level. After reaching the highest
value, the counter starts from the be‐
ginning again.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.