Sharp LC-32GA3E Service Manual page 47

TROUBLE SHOOTING TABLE
Set PATTERN1 → PATTERN1 on the adjustment process menu
to "2". Is the gray scale pattern displayed correctly?
Set PATTERN1 → PATTERN3 on the adjustment process menu
to "1". Is the gray scale pattern displayed correctly?
Set PATTERN1 → PATTERN3 on the adjustment process menu
to "4". Is the test pattern displayed correctly at intervals of one
dot?
Set PATTERN1 → PATTERN3 on the adjustment process menu
to "5". Is the test pattern displayed correctly at intervals of one
dot?
Check the peripheral circuits of IC4602.
Is OSTEMP.AD on Page 1 of the process adjustment mode set at
255?
Is the harness connected correctly between the inverter GND
PWB and LCD control PWB?
Is the input voltage at pin (62) of IC2004 (microprocessor) 5V?
The thermistor on the inverter GND PWB is faulty.
Is any of the fuses in the power supply unit blown?
NO
Is power supplied to the inverter PWB?
NO
Is the harness connected correctly between the PWBs (power
unit, inverter PWB, inverter GND PWB and LCD control PWB)?
NO
Connect the harness correctly or replace it.
Set PATTERN1 → PATTERN3 on the adjustment process menu
to "1". Is the gray scale pattern displayed correctly?
NO
Disconnect the FPC from SC4651 and SC4652. (To protect the
panel against damage)
YES
Check the power supply voltage supplied to the panel (check at
SC4651 and SC4652).
Data dropout (relating to gray scale)
NO
YES
NO
YES
NO
YES
NO
YES
Noise is caused to the moving picture with the QS drive on.
NO
YES
NO
YES
NO
YES
The backlight does not go on.
YES
YES
YES
The whole screen is whitish (LCD power supply).
YES
(Continued)
Check the connection between SC4651 and SC4652 and check
the peripheral circuits of IC4501.
Check IC4702, IC4902 and their peripheral circuits.
Check the line between IC4701 and IC4501.
Check the line between IC4901 and IC4501.
Check IC4701 and IC4901 and their peripheral circuits.
Connect the harness correctly or replace it.
Pin (62) of IC2004 (microprocessor) is faulty.
Check the inverter circuit located downstream from the blown
Check the connector and inverter circuit of each fluorescent lamp.
Is the control signal applied to pin (11) (OFL1) and pin (13)
(INV.OSC) of CN705 of the power supply unit?
Check the peripheral circuits of IC4501.
Check the video signal circuit.
47
LC-32GA3E
LC-37GA3E
YES
NO