Sharp XL-UR250H Operation Manual page 10

XL-UR250H(BK)
System connections (continued)
XL-UR2110H(BK)
Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position
the FM aerial wire in the direction where the strongest signal can be
received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and Earth (GND) terminals.
Position the AM loop aerial for optimum reception. Place the AM loop
aerial on a shelf, etc., or attach it to a stand or a wall with screws (not
supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling >
10
ANTENNA
FM
GND AM
75 OHMS
< Attaching to the wall >
Wall Screws (not supplied)
Speaker connection
Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
XL-UR250H(BK)
Use speakers with an impedance of 6 ohms or more, as lower
impedance speakers can damage the unit.
XL-UR2110H(BK)
Use speakers with an impedance of 4 ohms or more, as lower
impedance speakers can damage the unit.
XL-UR250H(BK)/XL-UR2110H(BK)
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
Do not stand or sit on the speakers. You may
be injured.
Speaker grilles are removable
Make sure nothing comes into contact
with the speaker diaphragm when you
remove the speaker grilles.
SPEAKERS
RATED SPEAKER IMPEDANCE:
6 OHMS MIN.
RIGHT LEFT
Red Black
Incorrect