Information Codes - Samsung WA40J3000A Series User Manual

troubleshooting

informAtion codes

The Washer may display information codes to help you understand what is occurring with your Washer better.
code symbol meaning
Hot LED Flashes
Warm LED
Flashes
Cold LED
Flashes
Tap Cold LED
Flashes
Extra Large LED
Flashes
Large LED
Flashes
Medium LED
Flashes
Small LED
Flashes
Hot & Warm
LEDs flash
WA3000J_WA40J3000AW_USER MANUAL_DC68-03520A-08.indd 28
Lid is open when washer is
running.
Communication error between
SUB PBA and MAIN PBA.
A button is not working properly.
The Water Level sensor is not
working properly.
When the Tap Cold LED is
flashing, the washer drains for
3 minutes. During this time, the
Power button is inoperative.
Your Washer has tried to fill but
was unsuccessful.
When the Extra Large LED
is flashing, the washer drains for
3 minutes. During this time, the
Power button is inoperative.
Check if the hot water supply
hose is connected.
Your Washer has tried to fill but
has not reached the proper water
level.
When the Large LED is
flashing, the washer drains for
3 minutes. During this time, the
Power button is inoperative.
A fault is detected in the water
level sensor.
Your washer is not draining. It can
also mean that the unit senses a
small clog while draining.
Unbalanced load prevented your
Washer from spinning.
English - 28
soluTion
Close the lid tightly and restart the cycle. If the
code reappears, call for service.
Call for service.
Call for service.
Call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, remove the
device and connect the water hoses directly to
the unit.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function.
Call for service.
Call for service.
Do the following:
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
If it still does not drain, call for service.
Redistribute the load, and then press the Start/
Pause button.
2015/12/22 13:45:15