Table of Contents
Advertisement
Figure 3 illustrates the installation of the indoor drain kit. The
indoor drain kit must be installed before placing the wall sleeve
into the opening. Install as follows:
1.
Locate the drain so that it will be on the room side of the
wall when the wall sleeve is installed.
˝
2.
Drill a 1/2
diameter hole in the base of the wall sleeve for
the drain.
˝
3.
Drill two (2) 5/32
pilot holes for the mounting screws.
These holes can be located using the drain kit as a
pattern.
4.
Assemble the drain kit as shown in Figure 3 and securely
fasten it to the wall sleeve with the screws provided. Use
o
either the 90
elbow or 6" straight fitting as required.
5.
Install the wall sleeve as described on pages 9, 10, or 11.
Figure 3. Indoor Drain Kit
Contractor to Drill
Three (3) Holes to
Accept Drain Kit
Figure 4. Outdoor Drain Kit
Installation of Optional Condensate Drain Kit
Square Drain Holes
Neoprene Sponge Gasket
Block Off Plate
Square Drain Holes
1
⁄
" O.D. Drain Tube
2
Neoprene Sponge Gasket
Steel Mounting Plate
Assembly of the outdoor drain kit should be completed after
the wall sleeve has been installed.
Note: When using the outdoor drain kit, the sleeve
must be flush or beyond the outside finished wall
(do not recess).
Install the outdoor drain kit as follows:
1.
Assemble the drain kit as shown in Figure 4.
2.
Choose the side of the wall sleeve to which the drain kit
is to be installed.
3.
There are drain holes and pilot holes provided in the wall
sleeve from factory. Place the drain kit against the cho-
sen drain hole and fasten securely with screws provided.
Use either the 90
4.
Cover the unused drain hole with the block off plate and
gasket supplied with the drain kit.
See Detail
Below
DETAIL
Steel Mounting
Plate
Screws
o
elbow or 6" straight fitting as required.
Gasket
Cabinet Bottom
Steel Mounting
Tube
Plate
IM 812 / Page 7 of 28
1
⁄
" O.D.
2
Advertisement
Table of Contents
