Advertisement
1
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
QQ
3 7 63 1515 0
A
1.1 FRONT, SURROUND SPEAKER
GRILLE
The grille is attached to the cabinet by its bosses applied with
adhesive.
To detach it, pry it open by inserting a flat blade screwdriver
into lower right and lower left slot.
To attach it, apply adhesive to the holes on the baffle. Then
press it to the baffle.
B
CAUTION
There are 10 bosses for press-fitting at the grille. To detach the
grille, remove in order from lower bosses. (Refer to the figure
in page 4.) In order not to damage the bosses, don't remove it
forcibly. Pry it open little by little. Be sure to insert a flat blade
screwdriver from just beside of its bosses.
WOOFER
The woofer is attached to the baffle by 4 external screws.
To detach it, unfasten those screws.
To detach it, first remove the grille. Then remove the screws.
C
When attaching it, face its terminal downward.
TWEETER
The tweeter is attached to the baffle by 3 external screws.
To detach it, unfasten those screws.
TE
L 13942296513
To detach it, first remove the grille. Then remove the screws.
When attaching it, face its terminal leftward and rightward.
D
1.2 CENTER SPEAKER
GRILLE
The grille assy is attached to the cabinet by 8 external screws.
To detach it, unfasten those screws.
SPEAKER UNIT
The speaker unit, together with the grille assy, is attached to the
cabinet by 4 external screws.
To detach it, first remove the grille assy. Next remove the cabi-
E
net. Then remove the cable.
When attaching it, face its terminal toward the input terminal.
www
F
2
1
http://www.xiaoyu163.com
2
x
ao
y
.
i
S-FCR4700
2
http://www.xiaoyu163.com
3
8
COSMETIC PANEL
The cosmetic panel is attached to the baffle by its bosses.
To detach it, pry it open by inserting a flat blade screwdriver
into lower slot.
To detach it, first remove the speaker stand base and grille.
Then remove the cosmetic panel.
When attaching it, fit the boss into the hole on the baffle.
SPEAKER STAND BASES
The speaker stand base is attached to the bottom of cabinet by 3
external screws.
To detach it, unfasten those screws.
Attach the speaker stand bases to the stems using the screws
provided. Once you have aligned the stem and base, secure
with the small screws at the points shown below. Note that the
speaker should face in the direction of the base of the isosceles
triangle (outlined below).
Q Q
3
6 7
1 3
Rear
Front
u163
.
3
4
2 9
9 4
2 8
1 5
0 5
8
2 9
9 4
Stem
(the bottom of cabinet)
Speaker Stand Base
m
co
4
9 9
2 8
9 9
Advertisement
