SkyScan 88905 Quick Setup Manual page 4

HOW TO SET THE TIME MANUALLY
In case the radio-controlled clock is not able to detect the WWVB-signal (disturbances,
transmitting distance, etc.); the time can be manually set. The clock will then work as a
normal Quartz clock.
Note: The time will be displayed with an additional "PM" for the time from 12:00 noon
until 11:59.
Note: The unit will still try to receive the signal every day despite it being manually set.
When it does receive the signal, it will change the manually set time into the received
time. During reception attempts the WWVB tower icon will flash. If reception has been
unsuccessful, then the WWVB tower icon will not appear but reception will still be
attempted the following hour.
After following the steps above and setting the Time zone and DST:
1. The hour digits will start flashing.
2. Set the desired hours by pressing and releasing the + key followed by pressing the
SET key.
3. Now the minute digits will start flashing.
4. Set the desired minutes by pressing and releasing the + key. If the + key is held, the
units will increase by 5.
5. Press and release the SET key to move to the "Year" setting.
YEAR
The year can be selected sequentially from 2001 to 2029 and will then start over again
(default setting 2009). The year will only appear in the manual setting mode.
1. The year digits will start flashing (only last 2 digits) on LCD2. Select the desired year
by use of the + key.
2. Press and release the SET key to switch to the "Month Setting".
MONTH
1. The month digit on LCD2 will start flashing (Default setting 1). Set the desired month
by use of the + key.
2. Press and release the SET key to move to the mode "Date Setting".