Using Crust Plate - Samsung CE1041DFB Owner's Instructions And Cooking Manual

jlXW[Xkmi†{sTWZ[W_|†luU”GGwˆŽŒGYWGG{œ™š‹ˆ SGhœŽœš›G\SGYWXWGGZaZ_Gwt

Using Crust Plate

Normally when cooking in microwave oven, using grill or microwave
EN
mode in grill/convection ovens, foods like pastries and pizza become
soggy from button side. Using the Samsung Crust plate helps to gain a
crispy cookde result of your food.
The crust plate can also be used for bacon, eggs, sausages, etc.
Before using the crust plate, preheat it by selecting the combination
mode for 3 to 5 minutes:
• Combination of convection (250°C) and microwaves
(600 W power level) or
• Combination of grill and microwaves (600 W power level)
1. Preheat the crust plate, as described above.
• Use oven gloves at all times as the crust plate will
become very hot.
2. Brush the plate with oil if you are cooking food, such as bacon
and eggs, in order to brown the food nicely.
3. Place the food on the crust plate.
• Do not place any recipients on the crust plate that are
not heat-resistant (plastic bowls for example).
4. Place the crust plate on the turntable or on the low rack in the
microwave oven.
• Never place the crust plate in the oven without the
turntable.
5. Press the Microwave +Grill (
6. Select the power level by pressing the Microwave +Grill
( ) button.
7. Set the cooking time by pressing 10min, 1min, and 10s
button until the appropriate cooking time is displayed.
8. Press the Start / +30s button.
Result: Cooking starts.
N When cooking has finished, the oven will beep
and flash "0" four times. The oven will then
beep one time per minute.
How to clean the crust plate
As the crust plate has a Teflon layer, if you use it incorrectly, it can be
damaged.
• Never cut the food on the plate. Remove the food from the plate
before cutting into slices.
• Turn the food over preferably with a plastic or wooden spatula.
) button.
19
The best way to clean the crust plate is to wash it with hot
water and detergent. Then rinse if off with clean water. Do not
use a scrubbing brush or a hard sponge otherwise the top
layer will be damaged.