Table of Contents
Advertisement
1
11
THERMOSTAT OPERATION
The heater is automatically controlled by a thermostat
to regulate the room temperature.
The easiest way to set the thermostat to your level of
comfort is as follows:
a. Turn the heater on.
b. Leave the heater running until the room has
reached your desired comfortable temperature.
c. Slowly turn the thermostat down until it clicks and
the heater stops.
d. The heater will now cycle on and off to keep the
room at the chosen temperature. Each time the heat
is turned on, it will return the room to this preset tem-
perature and then start cycling on and off. Should
you wish to raise or lower the room temperature, i.e.
during particularly cold spells, simply turn the ther-
mostat up or down accordingly.
Note: The thermostat switches the heater fully on or
fully off as the room temperature fluctuates. You do
not get 30% of the heat when the dial is turned
30% of the way round and 70% when it is turned
70% of the way round.
SWITCH OPERATION
The switch marked 0-1 controls the lamp and must be
turned on before the heater switch will operate.
The switch marked with 1 red bar controls the heater
inconjunction with the thermostat
UK PLUG ONLY
2.
REPLACE 13A FUSE
WITH SAME TYPE
3
Advertisement
Table of Contents
