Forward-Facing Installation; Vehicle Belt - Safety 1st Avenue Instruction Manual

4358-4548 Avenue 5/22/08 4:30 PM

Forward-Facing Installation

After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
WARNING:
!
A loose LATCH system can result in
serious injury or death.
Page 37
To install the child restraint,
use either the recline mode
or upright mode. For
upright mode, rotate
recline stand down and
out, then push up to lock.
When LATCH is not
available, fasten belt hooks
on side of child restraint as
shown.
34
Forward-Facing Installation with
Vehicle Belts:
Place child restraint
1
flush against the back of
the vehicle seat
forward-facing in the
back seat.
The recline position is to
be used only to install
the child restraint flush
against the back of the
vehicle seat back, if
needed.
Thread the vehicle lap
2
belt or lap/shoulder belt
combination through the
forward-facing belt path
and out other side.
Buckle.
Place one knee in the
3
child restraint and push
down firmly while
pulling up on belt to
tighten. For a manual
belt, refer to "Knowing
Your Vehicle Belt"
section.
35 continued on next page.