Definitions: Safety Guidelines The definitions below describe the level of severity for each signal FIG. 1 word. Please read the manual and pay attention to these symbols. EXTERNAL TOOL PARTS DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation which, if TRIGGER WITH not avoided, could result in death or serious injury.
Page 3
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY • Use couplings that relieve all pressure from the FIG. G • Use the tool only for its intended use. Do not WALT TOOL, CALL US AT: 1800 654 155 (Aust) or 0800 339258 (NZ). tool when it is disconnected from the power supply.
Page 4
• Choice of triggering method is important. Check FIG. M FIG. R FIG. 1 WARNING: ALWAYS use safety glasses. Everyday the manual for triggering options. eyeglasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR BUMP ACTION TRIGGER CERTIFIED SAFETY EQUIPMENT: •...
Page 5
OPERATION FIG. 4 BUMP ACTION TRIGGER - (BLACK) Preparing the Tool The bump action trigger’s intended use is for rapid nailing on flat, stationary surfaces. WARNING: Read the section titled Important Safety Instructions for Using the bump action trigger, two methods are available: place actuation Pneumatic Tools at the beginning of this manual.
Rafter Hook Repairs This warranty does not apply to • Accessories The D WALT framing nailers include an integrated rafter hook and can be To assure product SAFETY and RELIABILITY, repairs, maintenance and • Damage caused where repairs have been made or attempted by rotated to either side of the tool and can be folded out of the way when not adjustment (including brush inspection and replacement) should be others.
Page 7
TROUBLESHOOTING GUIDE Compressor will be sufficient for tools at all production rates. MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A D WALT SERVICE CENTER OR CALL 1800 654 155 (Aust) or 0800 339258 (NZ). Compressor will be sufficient at slow or moderate WARNING: To reduce the risk of serious personal injury, ALWAYS disconnect air from tool before all repairs.