Toro Groundsmaster 4100-D Service Manual page 32

8. Disconnect fuel supply hose from injection pump
(Fig. 13).
9. Remove throttle cable from engine (Figs. 13 and 14):
A. Remove lock nut that secures throttle cable swiv-
el to speed control lever.
B. Loosen cable clamp and remove throttle cable
from under clamp.
C. Position throttle cable away from the engine.
10.Remove fasteners that secure the upper radiator
shroud to the lower shroud and radiator (see Radiator
Removal in this section). Position coolant reservoir and
bracket away from the radiator. Remove upper radiator
shroud from machine.
11. Remove cooling fan motor and fan assembly (Fig.
15).
A. To prevent contamination of hydraulic system,
thoroughly clean exterior of fan motor and fittings.
B. Disconnect hydraulic hoses from cooling fan mo-
tor. Put caps or plugs on fittings and hoses to prevent
contamination. Label hydraulic hoses for proper as-
sembly.
C. Remove six (6) cap screws and flange nuts that
secure fan motor bracket to radiator.
D. Carefully remove cooling fan motor, fan and mo-
tor bracket assembly from machine.
12.On Groundsmaster 4110--D machines:
A. Remove windshield washer reservoir from reser-
voir mount on engine (Fig. 16). Position reservoir
away from engine. Do not remove reservoir mount
from engine.
B. Remove air conditioning compressor from brack-
ets (see Air Conditioning Compressor Removal in
the Service and Repairs section of Chapter 9 -- Oper-
ator Cab). Position compressor away from engine
taking care to not damage compressor or hoses.
Support compressor to make sure it will not fall dur-
ing engine removal.
C. Disconnect coolant hose from fitting on engine
water flange.
IMPORTANT: The hydraulic pump assembly can re-
main in machine during engine removal. To prevent
pump from shifting or falling, make sure to support
pump assembly before mounting fasteners are re-
moved.
Kubota Diesel Engine
13.Support hydraulic pump assembly. Remove fasten-
ers that secure pump assembly to engine (see Pump
Assembly Removal in the Service and Repairs section
of Chapter 4 -- Hydraulic System).
14.Make sure all cable ties securing the wiring harness,
fuel lines or hydraulic hoses to the engine are removed.
1. Lock nut
2. Throttle cable
3. Cable support
4. Lock nut
5. Washer head screw
6. Cap screw (2 used)
4
5
1
1. Fan
2. Fan motor bracket
3. Fan motor
Page 3 - - 14
11
10
1
9
4
7
5
2
Figure 14
7. Cable clamp
8. Spring washer (2 used)
9. Lock nut
10. Cable swivel
11. Cable stop
6
3
2
Figure 15
4. Cap screw (6 used)
5. Flange nut (6 used)
6. Radiator
Groundsmaster 4100--D/4110--D
3
8
6