Cleaning & Maintenance - Wahl CLIP‘N’RINSE Instruction Manual

CLIP 'N' RINSE
growing on the outside of the ear, simply move the rotary head
slowly along the edges of the ear.
WARNING:
other foreign object into the inner ear.
CLEANING AND MAINTENANCE
WARNING:
blades, simply rinse under running water then dry and oil the
blades.
Always unplug your transformer from the mains when cleaning the
blades.
CHANGING THE BLADE SET FOR CLIPPER
Ensure that the clipper is switched OFF.
The blade set can be removed by pressing the blades away from
the clipper.
To replace your blade, place the blade set with the hook engaged
into the slot in the housing and press down until it clicks into place.
OILING CLIPPER BLADES
The blades should be oiled before and after every use.
Simply place a few drops of Wahl Clipper oil on the teeth of the
blades. Switch the clipper on briefly (approx 10 seconds) to ensure
the oil film is evenly distributed. Use only the Wahl Clipper Oil
included in the pack. Due to the high speed of your Wahl clipper,
the correct type of oil must be used. Do not use hair oil grease
or any oil mixed with kerosene or any solvent, as the solvent will
evaporate and leave thick oil, slowing down the blades. Wahl
Clipper Oil is a very thin, natural oil which will not evaporate and
8
Do not insert the rotary head or any
Do not submerge the clipper in water, to clean the