Teldat VisorALARM+ Quick Installation Manual

1. Introduction

This Quick Installation Guide is designed to help the installation process of the VisorALARM+ and is
geared to quick reference and initial configuration; therefore this document contains information specific to
this aim and does not consider all possibilities.
VisorALARM+ installation manual or contact the Teldat Security technical service.

2. Requirements

Automation software
•
Automation Software compatible with Surgard, Radionics 6500 or Ademco 685 receivers and
an available RS-232 line.
Connections
•
Connection to an Ethernet network (10 or 100 Mbps).
•
Power connection 110-240 V AC.
Configuration
•
PC with serial port (speed 9600, 8 data bits, without parity bits, 1 stop bit and without flow
control) and terminal emulation software (e.g. Windows HyperTerminal).
•
RS serial cable for configuration (DB9 male – DB9 female).
Internet Connection
•
Static and public
1
If Internet access is behind a NAT / firewall, you must have a private static IP address and a UDP port redirected to the said private address.
VisorALARM+
Alarm Receiver over IP
QUICK INSTALLATION GUIDE
Dm 377-I, Version: 1.0
1
IP address for the VisorALARM+.
For further information on this please see the