Advertisement
TRML R
C
EMOTE
ONTROL
P
ROGRAMMING
Programmable features include line enable/disable and select all enable/disable. The TRML does not require
additional software for programming. Programming is accomplished using the standard front panel buttons on the
face of the remote allowing field programmability.
TRML's are shipped from the factory with all Lines and Select All buttons activated.
To enter the programming mode:
1. Remove power.
2. Press and hold the front panel TX button while reapplying power.
3. Once the LINE ACTIVITY indicators flash momentary in sequence and any of the green Line Select LED's
repeatedly flash on/off, release the TX button.
4. The TX LED will repeatedly flash on/off indicating the programming mode is activated.
Enabling/Disabling Line Select Buttons:
Note: Line is enabled when the green LED next to the button is "on". Line is disabled when green LED is "off".
1. Enter the programming mode.
2. Select or deselect the lines that are to be enabled or disabled indicated by the LED's.
3. Exit programming or move to next programming parameter.
Enabling/Disabling Select All Button:
Note: Select All is enabled when green LED next to button is "on". Select All is disabled when green LED is "off".
1. Enter the programming mode.
2. Select or deselect the Select All to enable or disabled indicated by the LED.
3. Exit programming or move to next programming parameter.
To exit the programming mode:
1. Press the front panel TX button one time.
2. Unit is now in normal operation with most recent programming parameters programmed.
O
PERATION
The operation of the TRML is designed, with the end user in mind, without the complexity of multi-programmable
buttons and over populated LCD displays. Individual buttons and indicators are used to provide straight forward
operation.
When power is applied to the unit, the LINE ACTIVITY indicators flash momentary in sequence, F1 frequency is
selected (models with multiple frequencies will have the indicator lit also), Line 1 is selected with indicator lit (or the
first available Line if line(s) have been disabled in programming). The unit is now ready for use.
Selecting a Line
Lines can be selected individually by pressing one of the LINE1 - LINE 4 buttons. The selected line is indicated by
the green illuminated LED next to the button.
Selecting Multiple Lines
Press the SELECT ALL button to activate the select all feature. Once the button has been pressed, a green LED
shows the Select All function has been activated and the user can now select and unselect desired lines to transmit
on using the LINE1-LINE4 buttons. The last selected line before entering into the Select All mode is still controlled
by the Selected Volume control and the other lines are controlled by the unselected volume control.
Pressing one of the F1 - F8 buttons will select the frequency and will send the corresponding function tone out the
selected line(s) and will light a green LED next to the frequency button pressed. The last selected frequency will be
the active frequency until a different frequency button is pressed.
13
C
ONSOLE
Advertisement
