Control Panel; Anti-Crease - Ariston Margherita 2000 Instructions For Installation And Use Manual

M
ARGHERITA
2000
Here I’m in command
Making the right choice is important. And it’s easy.
Programme selector knob
It is used to select the wash
programme.
Before setting anything, press
the on/off button (G). Lamp H
will begin to flash.
Remember that the knob can
only be turned in a clockwise
direction.
To select the programmes, the
mark situated on the control
panel must be aligned with the
symbol/number that corresponds
to the desired programme for at
least 5 seconds. After these 5
seconds, the setting is accepted,
lamp H stops flashing (staying lit)
and the wash cycle begins. If you
want to interrupt the programme
in progress or to set a new one,
select one of the symbols
(Stop/Reset) and wait for 5
seconds: when the cancellation
has been accepted, lamp H will
flash.
After the wash cycle has been set
and accepted by the washing
machine, turning the knob will
have no effect (except for when
it is on position Stop/Reset).
Temperature control knob
It is used to set the wash tempe-
rature in the recommended
programme table on pag. 4. It also
allows you to reduce the tempe-
rature recommended for the
selected programme, and even to
set a cold wash cycle ( ).
The detergent dispenser is here.
3
Margherita 2000 - Instructions for installation and use
C
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
Rapid wash
This button reduces the length of
the wash programme by about
30%. It cannot be used with
special programmes (see page 4)
or those for wool and silk.
Spin Exclusion
Press this button and the
washing machine will not carry
out a spin cycle, but rather a
drum spin at medium speed to
assist water draining. We
recommend that you use it when
washing garments which are
difficult to iron.
Extra Economy
Reduces water consumption
during the rinse cycles. We
recommend that you use this
function only with small laundry
loads, dosing the detergent
proportionally.
1
2
3
Understanding the control panel
On-off
When button G is pressed, the
washing machine is switched on,
when it is not the machine is
switched off.
Turning the appliance off does
not cancel the selected
programme.
The on-off lamp
Lamp H flashes when the
appliance is switched on and
awaiting a programme to be set.
A steady light means the
appliance has accepted the
selected programme.
The door block lamp
The safety lamp indicates that the
washing machine door is locked to
prevent it from being opened
accidentally. To avoid any damages
to lock mechanism, you must wait
for the lamp to extinguish, before
attempting to open the door which
takes around three minutes.

Anti-crease

This function (represented by the
symbol ) interrupts the wash
programme, keeping the washing
soaking in water before draining. It
is only enabled in programmes for
synthetic fabrics, silk and curtains.
It is very useful, because it prevents
delicate and synthetic fabrics from
creasing (for example, when you
cannot take the washing out at the
end of the wash cycle but only a
few hours later). The programme
can be completed by turning knob
A one notch. In the case of
synthetic fabrics, should you
prefer draining rather than a spin
cycle, turn knob A until you have
selected the symbol (Drain).
D F G
E I H
A
B