Sony KV-32XBR200 Service Manual page 30

KV-32XBR200/KV-36XBR200
H-CENTERING ADJUSTMENT
1. Input a monoscope signal.
2. Set to Standard Mode.
3. Push the "TEST + JUMP".
4. Set adjust the G2 VR that the raster appear.
5. Set H-SIZE minimum.
6. Adjust H-Center SW (S501) so that the margin width (no
raster) of left side and right side no raster area's width is
almost the same.
A
A=B
P&P SCON ADJUSTMENT
1. Input a color-bar signal signal.
2. Set to service adjustment mode and set to GON and BON to
"0".
3. Set P&P mode.
4. Connect an pscilloscope CN 1103 (6 pin) of A board.
5. Select MSCO (main) ISCO (sub) with 1
6. Adjust with 3
and
SUB
B
4.
and
6 as below.
1.75 ± 0.05Vp-p
MAIN
— 30 —