Subscribe to Our Youtube Channel
Summary of Contents for Suzuki Alarm System 2001 Ignis
- Page 1 SUZUKI IGNIS REMOTE CENTRAL LOCKING/ ENGINE IMMOBILISATION AND ALARM UPGRADE OPERATOR MANUAL...
-
Page 2: Table Of Contents
INDEX Page 1 1.0 Introduction Page 2 2.0 Contents Page 2 3.0 Operating Instructions: Immobiliser & Alarm Page 3&4 4.0 Diagnostic Table Page 5 5.0 Selectable Features Page 6 6.0 Transmitters Pages 7 7.0 Transmitter Programming Page 8 8.0 Battery Backup Siren ( Page 9 optional with Alarm Upgrade) 9.0 Care for Siren and Closing Remarks... -
Page 3: Introduction
SUZUKI dealer, who will be monitors the doors, bonnet, tailgate and happy to assist. ignition. An audible alarm and visual warning is given (if programmed ON) when a door... - Page 4 OPERATING INSTRUCTIONS ALARM BASE Page 3 3.0 OPERATING INSTRUCTIONS 1. Remote Locking / Arming Alarm Remote Unlocking / Disarming 3. LED FUNCTIONS Alarm Press the black button on the transmitter The LED has several functions which and the following will happen: Press the black button on the transmitter are explained as follows: •...
- Page 5 OPERATING INSTRUCTIONS Page 4 4.0 Auto Arming NOTE: If the immobiliser fails to To ensure maximum protection against The L.E.D. will turn on then turn off/on every theft of the vehicle, the system has been receive a coded signal from the five seconds.
-
Page 6: Diagnostic Table
DIAGNOSTIC TABLE Page 5 4.0 Diagnostic Table Should the dash-mounted L.E.D. continue to flash after disarming, it is an indication that the alarm has triggered during the armed period (if the alarm is programmed ON) To discover which sector was triggered, carry out the following procedure: •... -
Page 7: Selectable Features
SELECTABLE FEATURES (OPTIONAL ALARM) Page 6 5.0 SELECTABLE FEATURES • Exterior illumination (Factory Check to see if the correct selection • set “OFF” available in Alarm Arm/Disarm Chirps “ON” / ”OFF” has been made. If not, repeat the • mode only) Auto Re-Arming “ON”... -
Page 8: Transmitters Pages
CHANGING TRANSMITTER BATTERIES transmitters (Fig have noticeable features. Replacement transmitters are available from your Suzuki Dealer. Red Button Controls the panic (Fig 2) Battery Part No CR2032 or equivalent. alarm function. Battery life is approximately two years, Black Button Controls arming and depending on usage. -
Page 9: Transmitter Programming
TRANSMITTER PROGRAMMING PROCEDURE Page 8 • 7.0 PROGRAMMING TRANSMITTERS Note: When the ignition is turned ON the The vehicle’s indicators will flash 20 times to indicate successful entry. system will emit five chirps and the • When entering transmitter On the twentieth flash of the indicators flash five times. -
Page 10: Battery Backup Siren
BATTERY BACK UP SIREN Page 9 8.0 BATTERY BACKUP SIREN Turning the siren “OFF’ serves two purposes. Firstly, the system will no Alarm – Upgrade longer function as an alarm, although keyless entry is maintained. Secondly, it will prevent the siren from sounding The siren contains a rechargeable should vehicle’s... -
Page 11: Care For Siren And Closing Remarks
Suzuki cannot guarantee defence against theft of the vehicle and/or goods contained therein and is not liable for losses or damage to your vehicle. Please ensure compliance with insurance cover directives. - Page 12 Suzuki Rev (4) May, 2001...
Need help?
Do you have a question about the Alarm System 2001 Ignis and is the answer not in the manual?
Questions and answers
I have a 2001 Ignis but the transmitter no longer functions. How do I just use the key to operate the vehicle?
To operate a 2001 Suzuki Ignis using just the key if the alarm system transmitter is not functioning, follow these steps:
1. Unlock the Driver’s Door – Use the ignition key to manually unlock the driver’s door.
2. Insert the Key into the Ignition – Place the key into the ignition switch.
3. Turn the Ignition ON – This will activate the transponder system.
4. Wait for the Immobiliser to Disarm – If the correct signal is received, the immobiliser will disarm.
5. Start the Engine – Once the immobiliser is disarmed, turn the key to start the engine.
If the alarm sounds during this process, ignore it and continue. The alarm should disarm once the correct procedure is followed.
This answer is automatically generated