StetSom S 35 User Manual

SPECIFICATIONS
MODELO: S 35
Channels:
Power RMS: 35.200 Watts (1 OHM) @ 250V
Power RMS: 17.600 Watts (2 OHMs) @ 250V
Power RMS: 8.800 Watts (4 OHMs) @ 250V
Maximum Supply Voltage:
Frequency Response:
Crossover Low Pass:
Subsonic Filter:
Total Harmonioc Distortion:
Signal to Noise:
Sensitivity Minimum Input:
Input Impedance:
Minimum Output Impedance:
20 Batteries - 250V
14 Batteries - 176V
Bat. Automotive / Signal Musical:
Bat. Stationary / Sinal Musical:
Consumption / Sinal BASS:
Consumption Max @ 12,6V:
Dimensions (A x L x C) mm:
Weight:
NOTE: THE ABOVE SPECIFICATIONS ARE RELATED TO A SINGLE PRODUCT. SPEAKER IS DIVIDED IN
2 TO FACILITATE UNDERSTANDING OF THE VARIOUS APPLICATIONS (1 OHM and 0.5 OHM).
WHAT TO DO IN CASE OF PROBLEMS
NOT TURN ON:
- The cables are not properly connected (terminals +BATT, GND and REM). Make sure that all connections
are mechanical and electrical contact.
- Fuses / breakers (external) are defective or burned. Pay attention to the correct value of the new fuse!
NO SOUND:
- The cables of the speakers or RCA plugs are not connected correctly.
- Check that the LEVEL control is not in the minimum.
NO SOUND/PROTECTION RED LED FLASHING:
- See diagnosis UP (SYSTEM TROUBLESHOOTING).
- The speakers or cables defectives thus check the speakers, cables and connections.
POOR SOUND QUALITY (DISTORTION):
- The speakers are overloaded, therefore decrease the level and redo the gain setting (See item 2 /
OVERVIEW).
WEAK BASS:
- Cables speakers (+) and (-) are reversed, speaker out of phase (see Section 7 / overview).
MOTOR NOISE, HORN, SIGNAL LIGHT, ETC:
- Use suppressive cables in ignition candles.
- Use capacitors in the alternator, horn and ignition.
- Pass the RCA cable away from any other cable, because it is more sensitive to interference.
- Connect to power (+12 V) to separate the sound system. Use a fuse to 30 cm from the battery for
protection.
- Make a good grounding of the amplifier. To do this removes the paint from the chassis of the vehicle at the
desired point. Screw the cable using a ground terminal. To protect from oxidation, insulate with paint.
- Do not loop the ground wire. Avoid using several ground wires. Prefer a star connection, with all the
ground wires aside from a single point.
www.stetsom.com - export@stetsom.com
1 OHM 0,5 OHM
1 1
34.500 Watts (0,5 OHM
17.250 Watts (1 OHM) @ 176V
8.620 Watts (2 OHMs) @ 176V
315V 176V
(*
20 Hz to 2KHz - 0,5 OHM = RE)
50 Hz to 2KHz
20Hz to 80 Hz
< 1%
> 90 dB
0,2V
20K OHMS
1 OHM -
- 0,5 OHM
50A 50A
100A 100A
190A
20A
77 x 525 x 355
13 Kg
*
) @ 176V
Voltage
DANGER
HIGH
VOLTAGE
NOTICE
THIS PRODUCT
THREATENING
DEATH.
INDICATED ONLY
FOR PEOPLE
SPECIALIST .
High
Line
USER'S GUIDE
Nov/2011 - REV 1A